Go Auto

Why your next pickup should be a GM
Oddly enough, out of all of the research done into hybrid technology GM has been forward thinking enough to make theirs are not only affordable, but ingenious as well. They now offer both the Sierra and the Silverado pickups as hybrids country wide. Using a technology not formerly seen in hybrids, GM attempted to not only lower emissions in their pickups, but to make them handier as well. Affordable technologyGM wanted to make a hybrid truck that was too well priced to turn down, the major complaint of the hybrid models is high price tag which counteracts the gas mileage benefits. In response to this GM produced their pick up hybrids to cost only $1500.00-$2500.00 more than its gas guzzling brothers, saved with tax cuts at the pump within the first few years of ownership. Especially if you consider that the hybrids produce a 10% improvement in fuel economy, all without sacrificing any power. Both the Sierra and Silverado offer the same 245 horsepower V8 engine, and can tow up to 7,700 pounds. If you consider that pickup truck drivers are not sacrificing any power and when sitting stopped in traffic it emits very limited pollution for their size. Hybrid systemGM employs what they call a “flywheel alternator starter hybrid system” which uses a compact electric motor incorporated between the engine and the transmission. This electric engine runs the truck when it is slowing or idling at a standstill. They calibrate the flywheel alternator system to turn off the engine more frequently than even those systems used in most smaller hybrid models. Eliminating much of the pollution caused by slow moving traffic in high volume. Now your work truck can double as a generatorBoth the Sierra and the Silverado boost four 120-volt, 20 amp three-prong outlets which can be used to provide power for electrical tools and electronics. This eliminates any need for a gassy generator spewing fumes into the air at a work site. The truck must be running, but utilizing it’s electric engine allows it to run virtually emission free. GM reports that their hybrid trucks can continue to pump out power for up to 32 hours non-stop before needing to refuel. Aimed specifically at contractors, whose need to access abundant sources of energy and drive long miles to job sites fuel this intelligent new take on a work truck. Testers reportThe power source for tools was not quite as juicy as GM would have you think, however the idea is a brilliant one. No doubt in a few generations they will have nailed down this imperfection in an already forward thinking vehicle. Although the gas mileage is a tad better overall, it borders on insignificant. Which again is certain to be addressed and updated in generations to come. Reviewers say that the feel of the engine cutting out as you hit ten miles an hour is a bit disconcerting, and takes some getting used to, but its pollution saving benefits far outweigh that small detail. Every accessory on the truck is electrical, so the gas engine only runs when it is needed to for its sole purpose, to accelerate the vehicle. Overall appealThe brilliance behind the ideas developed for these pickup truck models is really what drives them at this point. Fine tuning is necessary of any piece of equipment and GM has been making pick up trucks for a long time. They will continue to address the issues and refine the existing good points, driving the hybrid market to continue to bring us new and innovative ideas. <b>About the Author:</b> My name is Paige Filler and I'm a creative writer with a love of all things that go vroom. I do my homework to bring thought and innovation into everything I write about the auto industry. You can find more of my stuff at <a href="http://www.cash4usedcars.com/" target="blank">Cash 4 Used Cars</a>, and <a href="http://blog.cash4usedcars.com/" target="blank"> this blog.</a>
Source: www.ArticlePros.com

Installing Aftermarket Head Units
Are you thinking about installing your own car stereo head unit? Be sure to read this article and figure out what you will need to do to get it done. Upgrading the sound system is usually one of the first modifications attempted when we talk about car customization. The best place to start is with a good head unit. If you plan to install it yourself, read on for some technical tips from our experience installers. You will need a few tools to do the job right, so start by collecting some screwdrivers (flat head and phillips head), a socket set, wire cutters, wire splitters, butt connectors or heat shrinking sleeves, electrical tape, zip ties, solder and a soldering iron, and some patience. The first thing I would do before installing I would suggest buying the stereo wiring harness for your vehicle application. This will make the installation easier for you if you are a beginner, and it allows for easier replacement of the stock radio (if you choose to sell the vehicle in the future) and swapping or upgrading to a different aftermarket head unit. Begin by disconnecting the negative battery cable from the battery. This will ensure that you don’t accidentally cross any wires and burn out a new piece of equipment. Next, remove the old head unit. If you need to see how this is done on your specific vehicle, you can look up your vehicles application on installdr.com. This is a great resource for seeing pictures of how to remove the head unit. Once it is loose, disconnect the wiring harness and the antenna from the head unit and remove it completely. There are two types of wiring harnesses you can get. There is the universal wiring harness that connects to your vehicles existing wiring harness, and has the unfinished wire ends that connect to the color coded wires of your new head unit. There is also a wiring harness that has a harness on both ends, and just clicks in place on both sides. These are the easiest to install, but can be harder ot find to match your vehicle to the head unit. Most wiring harnesses are the universal type, so we will focus on those. If you have obtained the wiring harness, you will notice the color coded wires in the back of the head unit. The wires on the head unit and wiring harness should match. The head unit wires and the wiring harness wires will be partially spliced for easy installation. There are several good ways to connect the wires. One way is to use butt connectors, which crimp the wires within a connector. These can be picked up almost anywhere that sells/installs head units, or at Walmart, etc. My favorite way requires a soldering iron and heat shrinking sleeves. Twist the wires together tightly. Apply just enough solder to weld the two wires together. Now fold them over parallel to one of the wires. Slide the sleeve over the connection and heat it with a heat gun or good hair dryer. I have had to rewire or repair systems where butt connectors were used, but this could be installer error, and not a problem with the connectors themselves. I have never had any of the soldered connections fail. Once all the connections are made, and the sleeves heated and shrunk in place, I like to take a zip tie and tie them all together. Clip the excess zip tie for a clean finished look. Connect the wiring harness of the head unit to the wiring harness connected to the vehicle. Plug in the antenna (you may find you need an antenna adapter in some applications). Now slide the head unit in place, but don’t attach it yet. Reconnect the negative battery cable and turn on the head unit (make sure the key is turned to the ACC position). It should be functioning properly at this point. If you plan on adding an amp, or have purchased one for this setup, turn the unit off and connect the RCA cables. Run them through the dash to the floorboard and to the amp (more on how to successfully do this in future articles). If you encounter problems, you can email <A HREF="mailto:support@majesticmodifications.com">support@majesticmodifications.com</A> for help. Brought to you by <A HREF="http://www.majesticmodifications.com" TARGET="_blank">http://www.majesticmodifications.com</A>. Majestic Modifications is your online source for auto parts and accessories, installations advice and technical support.
Source: www.ArticlePros.com

Advantages Of Diesel Engines
If you wanted to own a new car powered by a diesel engine or if you own one now, you no doubt appreciate the qualities this engine provides you with. More torque, better fuel economy, and easier maintenance are but a few of the attributes of owning diesel powered vehicles . However, there are some motorists that still complain about the engine’s weak power, especially when accelerating from a full stop. What you may not be aware of is the fact that a diesel engine can be tweaked to give more power without harming the fuel economy . New diesel engines cars use air compression to create combustion versus the fuel/air mixture that is required by gas engines. This attribute means that diesel engines don’t require spark plugs and therefore don’t need to be tuned up . Diesel fuel has a much high fuel density than gas, which results in fuel economy increases of 20 - 30% over gasoline powered vehicles . Diesel engines are also cheaper to maintain as they have less parts than that of a gasoline powered engine. The life span of a diesel engine is also much longer . If you’re looking for torque, for pulling a boat or other equipment, then the diesel engine has the supreme advantage. Diesel engines are surely slower, especially when starting from a dead stop, although when you climb hills or go over bridges, the diesel engine is surely up to the task . With new trucks, diesel is normally the leader over gas engines in terms of performance and miles per gallon. Diesel trucks will get more miles than gas trucks, and the price for diesel is a bit cheaper than gas these days . And with gas prices on the rise, diesel will continue to dominate for a long time to come . http://www.new-carpurchase.blogspot.comDiesel engines are also cheaper to maintain as they have less parts than that of a gasoline powered engine. The life span of a diesel engine is also much longer . If you’re looking for torque, for pulling a boat or other equipment, then the diesel engine has the supreme advantage. Diesel engines are surely slower, especially when starting from a dead stop, although when you climb hills or go over bridges, the diesel engine is surely up to the task . With new trucks, diesel is normally the leader over gas engines in terms of performance and miles per gallon. Diesel trucks will get more miles than gas trucks, and the price for diesel is a bit cheaper than gas these days . And with gas prices on the rise, diesel will continue to dominate for a long time to come . http://www.new-carpurchase.blogspot.com
Source: www.ArticlePros.com